Support   How to purchase  Tel: 516-625-5608     Contact Form
PerfectCue
 
Intro
Set-ups
Features
Navigation
Programmer
User Guide
PerfectCue Mini
PerfectCue Micro
Transmitters
Accessories
Prices
Batteries
FAQ
Technical Documents
   
   
cue lights — features
1 Local Actuators
Activate lights on connected units
Green (Next)
Yellow (Screen blank)
Red (Back)


2 LIGHT
Control brightness.
Hi. Lo. Off.


3 SOUND
Control speaker volume:
Hi. Lo. Off.
Selected sound cue is still delivered through headphone jack when speaker is off..


4 SELECT
Unique sound cues for Next, Back, Screen blank.
Check l l
  A brief local alert
Command ll l...
  Intrusive prompt
Announce ll... ll...
  Melodic note group


5 AUTO COMMAND
Engage or disengage USB connection to either or both computers without rebooting.
Remotely control presentation software.

6 YELLOW LIGHT
Corresponds to screen blank. Light stays on until any key is pressed.

1 CHANNEL
Set for multi-unit proximate use. 16 channels available. Match channel on cue light and actuator.

2 RJ45 Jack
For cue light interconnections with Cat 5 cable

3 XLR Jack
For cue light interconnections using microphone (XLR) cable.

4 Sound Volume Control
Adjusts volume of cue light sound to 3.5 mm side jack (No 6) and to 4-pin side XLR jack for belt-pack intercom headset. (Note: Does not affect volume of communications to the headset.)

6 Output 3.5 mm Headset Jack
Stereo jack outputs programmable sounds that correspond to Forward, Back and Screen Blank commands.

6 Output XLR Headset Jack
Output to beltpack intercom headset with cue light sounds combined with unchanged intercom communications.



7 Slave-Master Switch
When two or more cue lights are connected by wire (Cat-5 or XLR cable, set one cue light as "Master" and the other(s) as "Slave." Only the Master cue light receives the trnasmitter's signal.
8 USB PORTS
For direct computer connection.
Cue light sends commands “Right Arrow,” “Left Arrow” and “B” via keyboard emulation, thus preserving mouse functionality. Note: These keystrokes are programmable. See Cue Light Programmer to download programmer application.
9 Power Jack
Use DSan-supplied 12V power supply (center pin +).

10 MONITOR AUDIO INPUT
Accepts stereo 3.5 mm phono plug. Allows operator to monitor stage presentation. Cue light sounds may be combined with this input

11 HEADPHONE OUTPUT
Operates independently of onboard speaker. Combines cue sounds with audio input with matched volume.



Next: Navigation

@ 2017 DSan Corporation Tel 516-625-5608 Email: sales@dsan..com
142 Mineola Avenue Roslyn Heights, New York 11577